Saturday, November 21, 2026

The trials and tribulations of a handy guy

Don just finished writing an article on hammers. He contributes to a rural-themed magazine and is something of their tool expert, so he was asked to write a basic primer on the most commonly used hammers needed around the homestead.

This is all fine and dandy, but now he needs to provide a few photos to illustrate the piece. The issue? He can't find his hammers.

Oh sure, he's found a few examples of the types of hammers he discusses in the article (mallet, five-pound sledge, brad hammer, small claw hammer, framing hammers), but he cannot – for the life of him – find any of his good claw hammers (he has several) nor his sledge hammer.

He has searched high and low. Every shed. Every corner of the barn. Every shelf. Every closet. Every tote and crate and box. He's now opening random drawers in the house where he knows they can't be, simply because he's running out of places to look.

But, because he needs those photos before he can submit the article, he is reduced to asking a neighbor if he can borrow a couple of claw hammers and a sledge hammer for about ten minutes, just long enough to take some photos.

The thing is, he knows why he can't find these tools: Because he was using them. And, being absent-minded in general, it's not unusual for him to put things down and forget where they are.

And of course, the moment he doesn't need them, he will literally stumble across them. He will trip over the sledge hammer. The claw hammers will drop from a ceiling panel onto his head or something.

Ah, the trials and tribulations of a handy guy...

5 comments:

  1. Forgetting stuff is my superpower.
    Fitty

    ReplyDelete
  2. I’ve begun taping fluorescent tape to my tools so they stand out when I’m cleaning up after a job. That could help him in the future.

    ReplyDelete
  3. There’s a gene for that. As his sister, I would know!

    ReplyDelete
  4. The best way to find lost tools is to buy a new one-works every time!

    ReplyDelete
  5. Does he know where his 10mm socket(s) is/are?

    ReplyDelete